What is the reason for modules to switch on/off spontaneously?
It is possible that a PLCBUS System is installed at one of your neighbors using the same User Code. To solve this problem try to change the User Code of your system.
My Modules will not respone to my controller?
Make sure that the House Code on all Modules and Controllers are set to the same House Code (A-P)
My modules will not react to my remote / Sensor?
When you use a remote or sensor , you should have a least one PLCBUS-4023UK Transceiver installed in your house. These components will translate the radio signals to PLCBUS signal on the power line. Only one Transceiver should be installed for all remotes and sensors set to the same House Code
Am I able to increase the range of my remotes by using more Transceivers?
Yes , you can use more than one PLCBUS-4023UK Transceivers in your home when the range of your remotes is not sufficient. The PLCBUS-4023UK is using so called collision detection to prevent signals to be distrubed when more than one PLCBUS-4023UK Transceiver will wait for a quite power line before transmitting their data. To prevent your PLCBUS System to become slow or to prevent dimming from becoming less smooth, make sure that the PLCBUS-4023UK units are placed as far away from each other as possible. Ore you can add a RF Repeater to amplify the RF Signal.